Select the corner where you would like to hang your MaxTrap. Ideally, the center of the MaxTrap should be placed at the same height as your ears when seated in your listening position but this is flexible if room décor or listening position dictates otherwise.

1. Use a bubble level and pencil to make two horizontal lines out from the corner where you want the top of the MaxTrap to be.

2. Measure out from the corner 8.5 inches and mark a vertical line. This line represents the edge of the beveled wall cleat that will be closest to the corner.

3. From the top line measure down 3.75 inches and mark a short horizontal line. This line represents the top of the beveled wall cleat.

4. Pre-drill two 1/8” holes in each beveled wall cleat. Drive two heavy duty Phillips screw into each wall cleat so the tips of the screws slightly protrude. This will help to mark the plastic anchor locations in the next step.

5. Line the beveled wall cleats up with the lines you marked on the wall in steps 2 and 3. Press the screw tips into the wall to mark the positions for the plastic drywall anchors.

6. Push the four plastic anchors into the wall where you marked in step 5. Tap lightly with a hammer to drive the anchor in and screw the plastic anchor flush to the wall.

7. Screw the beveled wall cleats into the plastic anchors. Ensure the beveled edge is on top and facing the wall as shown in the step 8 diagram.

8. The beveled edges on the wall and frame cleats lock together to safely support the MaxTrap.

9. With the help of a second person, lift the completed MaxTrap assembly up and gently rest the back of the Maxtrap down onto the beveled wall cleats.